1. Support 1730/1725 meters. MUST work in Firmware >= v2.0.

2. Support multiple engines and multiple sensors' balance.

3. Support different balance speed entry for different sensors.

4. With ability to review/print summary of all balance jobs for all sub-models (now only one sub-model in the procedure card).

5. 1-17-97: Added "High/Low Tooth: Enabled/Disabled" option in "Change Global Settings" of [main menu] (default: Disabled).

6. 1-17-97: Changed version from v1.00 to v3.00.

VERSION 3.01, 12/04/97

1. Employed Weighted Least Squares in solution calculation.

2. Added Sensor/Tach Location definition during job setup.

3. Moved "Default/Previous/Editing" ICF to global.

4. On first run weight placement, limit to one weight, changeable in Global settings.

5. Added back 511 cable fault detectors to sensor list. Append w/511 on the sensor description.

6. Added "Survey with Tach".

7. Added picking balance speeds by "User Entry / Engine Survey" during balance job setup.

8. At first entry to main menu, set serial port baud to 9600.

9. Allow "Survey with Tach" to use High-Low-Setting set in Global Settings.

10.Correct Demo Banner when survey exits from survey screen if doing survey in Demo Mode.

VERSION 3.02, 01/18/98

1. Set engine to IDLE (not Shutdown) for Vib survey during balance. So no "Start Engine" is necessary in the 1st run of balance.

2. Allow to resume the run correctly when press RESET at the weight entry screen.

3. Default to NO (re-enter weight) at the "Re-enter Weight Query Screen" at 1st run if NO weight-split is allowed at the 1st run.

4. Added a logic to ensure the later runs is not affected by the wrong initial weight placement due to the wrong initial ICFs, and hence to ensure the engine can be balanced properly.

VERSION 3.20, 03/23/99

1. Fully support Year 2000 format (no versions between v3.04 & v3.20).

2. Fix possible survey loosing job.

3. Add auto prompt & deleting Oldest Jobs with user selections when memory is not enough.

4. New features as AE3007 V3.22.

VERSION 3.21, 07/06/99

1. Uses Varied Band Width balance, you can setup the band width in the "Change Global Settings" menu. In the band list, include "Normal " band setting (Default). If you select  "Normal ", the balance is just like before (Normal band balance).

VERSION 3.22, 07/24/99

1. Fixed possible bug in Varied Band Width balance due to the interrupted Date-Time-Banner. Now, the balance acquisition does NOT use the interrupted Date-Time-Banner.